Excellent thermal effect, no glue edges!

 This point is a little technical content in it, simply put, hot stamping need glue, some hot stamping has no technical content, directly use glue to print on, in the printing press, the glue will be a lot of overflow on the edge of the pattern, forming a layer of transparent glue edge, in the dark fabric, it is difficult to see the explosion! Especially when making thin lines, the glue edge of the edge of the minute to add several times the thick line!

The Vision digital Technology 6504 DTF Printer is a high-end solution that delivers high-quality printing at an affordable price. Using high pressure and temperature, the ink is permeated into the fabric, and a very small amount of glue is used to blend with the ink, no glue edges, and no brightening agent is added.

The process of hot stamping is very important, if you do not grasp the degree, it is easy to waste materials, of course, not so terrible, with the rapid development of the digital industry, the emergence of thermal transfer paper, to avoid a lot of small problems that will appear in the past. But still have to do these steps, in order to achieve the best effect of hot stamping.

The first is the determination of the pressure, the pressure of the hot stamping machine is a constant standard, if the pressure is too large, it will produce the compression deformation of the hot material, the most direct is to cause the deformation of the pattern. If the pressure is too small, it is easy to cause the substrate to not adhere to the paper, and the fastness will be greatly discounted. Therefore, in the process of hot stamping, we must pay attention to the uniformity of each pressure point, and the pressure Angle of the substrate and the hot stamping wheel is higher.

Then there is the requirement of speed, which is determined based on the stamping area, and it is very important to consider the power of the thermal temperature. First the velocity, then the pressure, and finally the temperature.

Finally is the temperature control, if the temperature is too high, it is easy to burn the pattern! If the temperature is too low, it will cause the hot printing is not strong or directly hot printing is not up, and it is easy to appear dim color and fuzzy printing. Therefore, the best temperature control for hot stamping is in the range of 180℃ -220 ℃. Warm tip: When the temperature is determined, it must be kept constant, and there can be no excessive fluctuations.

Heat stamping to achieve the best results, temperature, time, pressure, excellent ink, high-end technology is essential.

Good hot stamping, fine pattern, bright color. In short, good-looking!

The DTF Printer solution and ink produced by Vision digital Technology can achieve the perfect combination of the above effects. The machine brand RAY-JET, the ink brand Vision-Color, the PET film with uniform coating, the powder with medium and fine particles.

Welcome to try! Also can visit our website: www.dtfsolution.com and https://visionprinter.en.alibaba.com/ and we are made - in - China on B2B shop links: https://visionprinter.en.made-in-china.com/.